The most productive solution for outerwear
FM 14L / 16
Benefits as for FM 1000/1400, plus:
- Ideally suited for coats, winter fabrics and block fusing
- Extended heating zone, increased productivity (length 1400 mm – 55.12 inch)
- Three heating zones, more gentle heating
- For large-scale production or centralised fusing
- Ideal for combination with feeding systems (FE-L, ET)
The control panel – Never before has a fusing machine been so easy to operate.
Focussing on the essential and combining it with an intuitive operation – these have been our goals in designing the new 7“ colour touch screen control panel.
All the relevant fusing parameters are available at a single glance on the modern, user-friendly display. In the event of a parameter digressing from the pre-set values, say temperature is too low, the font colour turns into red and the feeding belt stops further feeding into the machine.
The integrated web server allows the VEIT Remote Service to diagnose the machine remotely.
- Language selection
- USB port for printer or for making programme copies
- Diagnostic system for the proper functioning of heatingelements, compressed air supply, belt running, error log
- Shift Management
- Remote Service
- Capacitive touch display
- IO Link connection
- Integrated OPCUA server
All the relevant fusing parameters are available at a single glance on the modern, user-friendly display:
- Set temperature of first heating zone
- Actual value of first heating zone
- Contact pressure of first pressure system displayed in bar or N/cm²
- Belt speed in m/min and seconds
- Stand-by function for energy-saving during breaks
- Heating on/off
- Cool-down function for cooling the belt and cleaning
- Actual value of second heating zone
- Set temperature of second heating zone
Ergonomics and Visibility – Everything in view and easy to reach
In the design and construction of the FM/LM series, particular attention was paid to further optimising the ergonomic wishes of our customers.In addition to reducing the basic height of the machine series, the important points for the production process were made more acces-sible and visible.The area of the transfer from the FE to the conveyor belt was adap-ted so that the materials can be better observed during the transfer. This helps to prevent misfixing.
The enlarged rear flap allows a clear view of the stripper and the transfer to the cooling belt, and thus an immediate visual check of the fusing results. In combination with the reduced machine width in the area of the cooling station, accessibility to the stripper has been made much easier.